Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW

Equipment

1669 shop tips and stories · page 3 of 28, newest issues first.

From the archive · Full text
Reader shop tip

Ed Doucette

Ed Doucette, Fort Ripley, Minn.

“My Allis Chalmers diesel would not start after replacing the fuel filter on the 1970 Perkins 3-cyl. diesel. Bio-diesel ruined my entire fuel system. I spent $800 to have the injection pump rebuilt and you should have seen…

Read the complete tip →
From the archive · Full text
Reader shop tip

Tony Ryba

Tony Ryba, Johnstown, Penn.

“My Briggs & Stratton lawnmower engine lost compression due to carbon buildup on the exhaust valve, which held it open. After cleaning and lapping in both valves and seats, it was time for reassembly.

Read the complete tip →
From the archive · Full text
Reader shop tip

Dan Erdman

Dan Erdman, Claresholm, Alta.

“My riding lawn mower drive belt had been slipping. I’d put belt dressing on, and it would work for a while and then continue slipping. This morning I put a new drive belt on, and it started slipping.

Read the complete tip →
From the archive · Full text
Reader shop tip 1 of 2

Tim Ojala

Individual tip 1 of 2 from this reader’s published contribution.
Tim Ojala, New Ipswich, N.H.

“We do tree cutting and sometimes I have four saws on the job. I take the boot off the saw and mark one edge with a black marker. Then, if the saw chain needs sharpening, I turn the…

Read the complete tip →
From the archive · Full text
Reader shop tip 2 of 2

Tim Ojala

Individual tip 2 of 2 from this reader’s published contribution.
Tim Ojala, New Ipswich, N.H.

“I used to dread putting tire chains on our tractor, loader and forklift in the winter. I found it works well to lay out the chains on the ground behind the wheel and then back up onto the…

Read the complete tip →
From the archive · Full text
Reader shop tip 2 of 2

Charlie Matthews

Individual tip 2 of 2 from this reader’s published contribution.
Charlie Matthews, Petersburg, Tenn.

“The next time you need to remove the mower deck from under your riding mower, turn it upside down, wire brush it and then spray it with those leftover, almost empty cans of spray paint you’ve been saving.…

Read the complete tip →
From the archive · Full text
Reader shop tip 2 of 3

John Rochester

Individual tip 2 of 3 from this reader’s published contribution.
John Rochester, Charlotte, N.C.

“The new battery I put in my wife’s older car has no handle and is a real bear to lift out of the engine compartment. So, I cut a piece of 4-in. cargo strap and put it under…

Read the complete tip →
From the archive · Full text
Reader shop tip 3 of 3

John Rochester

Individual tip 3 of 3 from this reader’s published contribution.
John Rochester, Charlotte, N.C.

“Here’s an easy way to make a portable workbench. I attach wood planks to either side of the bucket on my loader tractor and then lay a piece of plywood across them, held in place by couple of…

Read the complete tip →
From the archive · Full text
Reader shop tip 1 of 2

Don Klassen

Individual tip 1 of 2 from this reader’s published contribution.
Don Klassen, Harrisburg, S. Dak.

I was frustrated by anchors on small steel electric fenceposts that would bend, keeping me from pushing them into hard soil with my foot. So, I made a lightweight post driver with a length of 1/2-in. dia. pipe…

Read the complete tip →