Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 47, No. 1 (2023)

Jib Crane Added To Walk-Behind Forklift

By Bruce Derksen, Contributing Editor
Featured source: Randy Boyce, Marshalltown, Iowa
Jib Crane Added To Walk-Behind Forklift
Photo: FARM SHOW · Vol. 47, No. 1 (2023) · p. 32

When Randy Boyce needed something to lift heavy parts for his restoration business, he thought adding a boom and jib crane to his walk-behind Burro 6162 forklift might be exactly what he was looking for.

He left the Burro standard, with its 14-hp. Honda motor and 3-lever hydraulic system that controlled the boom, forks, 24-in. reach extension plus the electric winch.

To support his extended boom, Boyce welded a framework of 1/2-in. thick by 3-in. boiler pipe for upright legs and upper horizontal supports. He added metal pockets for the forklift tines to slide into to lift the unit.

The exterior boom is 8-in. square tubing with the interior telescoping beam slightly smaller. He welded a handle on the end for manual positioning, using a 1-in. pin to secure it every 2 ft. A large pivot pin supports the boom at the forklift mast with four U-bolts added for extra stability.

“When fully extended, I can lift the tail end of my van with it,” says Boyce.

“The winch is also great for lifting. I just run the cable around the end through a pulley.”

With the forks lowered, the boom reaches out to an 8 ft. height. In the raised position, it extends up to 16 ft. when fully telescoped.

“If I were to build it again, I’d make the main pivot pin fit a bit better,” Boyce says.

“It’s a little tight, so I need to use a hammer to slip it in and out.”

He built and welded the jib crane from scratch and estimates he put slightly less than $1,000 into the project.

Contact: FARM SHOW Followup, Randall Boyce, Quality Auto Repair, 1755 Oaks Avenue, Marshalltown, Iowa 50158 (ph 641-753-9468; [email protected]; www.qualityauto56.com).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.