Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 44, No. 1 (2020)

Trailer Jack “Roller Stand”

Featured source: Lee Johnson

“I built this infinitely adjustable roller stand out of round stock and square tubing. I use it with my bandsaw when handling long material. A trailer jack makes it easy to adjust the height,” says Lee Johnson, Richburg, S.C.

Johnson uses the roller stand in his shop, along with a couple other ones that he built. When spaced 6 ft. apart, they provide a sliding surface for moving long objects into the saw.

The roller stand’s base is made from an old 20-in. disk coulter. Johnson welded a length of 1/2-in. round stock vertically onto the coulter and then slid 1-in. square tubing over it, welding the tubing to the jack. At the top of the stand, a 12-in. long conveyor roller with spring-loaded ends spins freely on a 13-in. horizontal steel bracket made from 1/2-in. wide, 3/16-in. thick metal. The bracket has a short vertical piece at each end with a hole drilled into it, where the spring-loaded ends fit through. A welded-on, triangle-shaped metal gusset reinforces the bracket.

Contact: FARM SHOW Followup, Lee Johnson, 4036 Hayward Lane, Richburg, S.C. 29729 (ph 803 517-4131; [email protected]).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.