“I needed a little belt grinder for touching up ends of threaded rod, so I made one from an old cordless 4 1/2-in grinder,” says Allan Isaac. He made a machined flat pulley on his lathe to screw on to the grinder shaft and built a steel frame to mount a 2 by 30-in. belt. He fabricated 1 1/4-in. tubing with smaller tubing inside to hold the implement bearing shaft he purchased at a farm supply store.
“The secret to keep the belt in alignment is the 3 bolts that go against the bearing shaft that can be adjusted,” Isaac says. To change the belt, he loosens the crank screw that tensions the belt, slips on a new belt, and tightens it up again lining it up with the bearing and a horizontal steel plate.
“The nice part about it is if you need something ground flat, you just hold it up against it,” Isaac says. Because it is powered with a battery, the belt grinder is portable, and Isaac keeps it handy on the edge of his workbench. Contact: FARM SHOW Followup, Allan Isaac, 4031 Old Alaska Highway, Farmington, B.C. Canada (ph 250 794-1416; [email protected]).
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.