Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 42, No. 2 (2018)

Ted Kalvitis

Ted Kalvitis, Romney, W. Va.

“Congratulations to the FARM SHOW reader who beat a proposed $1,800 repair bill when the clutch cross-shaft on his Kubota tractor seized in the bell housing. While he realized success with a mixture of acetone and transmission fluid, the method I’ve been using in my mobile tractor repair business works well when a more permanent arrangement is called for.

“I simply drill a small hole in the bell housing until the drill reaches the cross-shaft. This is easy to determine because the shaft is much harder than the cast bell housing. After extracting all the cuttings, I then thread the hole and install a grease fitting. Sometimes it takes some heat to get the grease moving. I warn my customers not to over-grease the fitting so that excess grease doesn’t get on the clutch surface.

“I mentioned my idea to the service manager at a Kubota dealership where they customarily split the tractor in half to gain access to this shaft – at a $2,000 cost for labor. He just stared at me for a very long moment before the conversation resumed.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.