Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 42, No. 2 (2018)

Randolph Walker

Randolph Walker, Charlotte Court House, Va.

“After about 15 years of use, my Marlow irrigation pump wouldn’t prime any more. When I took it apart I discovered that not only was the seal on the impeller shaft bad, but also the shaft itself was so badly pitted that a new seal wasn’t going to solve the problem. The shaft and impeller is a one-piece unit and is quite expensive to replace.

“After cleaning the shaft thoroughly, I put a liberal coating of J-B Weld epoxy on the pitted part and continued to rotate the shaft by hand until the epoxy began to harden. After letting the patch thoroughly cure for a couple of days, I ran the pump at idle and used a file and sandpaper to work the epoxy down so the new seal would be air tight. I made this repair more than 20 years ago and it’s still working great.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.