Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 38, No. 5 (2014)

He Made His Own Transmission Tool

Featured source: Steve Bellaw

The truck Steve Bellaw bought used had a bad automatic transmission that needed to be rebuilt. To rebuild it, he needed a clutch spring compressor.

“It’s used to keep things from flying apart,” says Bellaw.

“The auto parts store wanted $200 for the tool, but I couldn’t justify the money.” After looking closely at the commercial version, Bellaw decided to try making it. He describes it as looking a bit like a backwards gear puller, pushing instead of pulling. It presses on the retaining washer in the clutch drum to compress the clutch piston return springs. This allows him to remove and later re-install the snap ring.

“I used 3/8-in. steel that was 3/4 in. wide for all the pieces,” says Bellaw.

“I drilled out a hole in a 4 1/2-in. long piece to make a T-handle for the carriage bolt that does the pushing. I welded the bolt in place.” He cut 2 slots in a 6-in. long piece of the steel and threaded a hole in the center for the carriage bolt. The spring retaining arms are 3 in. long with holes drilled and threaded in one end of each for bolts. Once properly spaced to match the size of the spring, wing nuts secure them in place. For a “pusher” plate, Bellaw machined a circle of 3/8-in. steel and threaded it for the carriage bolt. He installed a lock nut at the end of the bolt.

“It took a little lathe work and some machining, but it works great,” says Bellaw.

“I’ve used it for other applications and loaned it out to friends. Bottom line is don’t let them tell you that you need a special tool or part. You can always come up with something.” Contact: FARM SHOW Followup, Steve Bellaw, 408 Valley View Dr., Piketon, Ohio 45661 (ph 740 443-5030; [email protected]).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.