Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 37, No. 2 (2013)

Jeff Heiser

Jeff Heiser, Vesper, Wis.

“I had to install hard plastic seals on the 3-pt. arms of a Deere 2030 tractor at the lower end of the transmission case. The seals were hard to handle so I put some oil in a small soup can and carefully heated the can with a propane torch to bring the oil to a boil. Then I dipped each plastic ring in the can with a pair of needle nose pliers and swished them around for a minute or two. At that point the seal would become pliable enough to insert into the transmission housing casting. I would pinch to make a half moon shape and insert quickly, then reform into a circle shape and insert the pin.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.