Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 36, No. 4 (2012)

Tavish Presswood

Individual tip 2 of 2 from this reader’s published contribution.
Tavish Presswood, Canton, Ga.

“I needed to get rid of some big dents in the sides of my Bush Hog mower, which were caused by turning too short around trees. To straighten out the dents I made a notch in a 1/2-in. thick piece of flat steel bar and welded it to a 6-ft. length of 2-in. dia. pipe that’s curved upward at one end. I use the pipe like a crowbar, placing the notch under the edge of the bush hog’s sides to pry the dents out. It was a lot easier than climbing up under and using a hammer.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.