Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 36, No. 1 (2012)

Ken Brading

Ken Brading, Atascadero, Calif.

“In your last issue, a reader told how he bends thin wall tubing by filling it with sand and plugging both ends to keep it from collapsing.

“I once had to replumb the exhaust tube on an air compressor. The space was too tight to bend a simple elbow and still get the necessary insertion into the compression fittings on both ends. To get flexibility through length, I coiled a length of aluminum tubing as shown in the photo. I crimped one end of the tube closed, packed it full of extremely fine grain sand by tapping the crimped end on a bench vise, and then crimped the other end so the tube was tightly packed with sand. Wearing insulated gloves, I heated the packed tube with a propane torch and slowly fashioned it into a coil. The extra length in the coil gave enough flexibility to hook it up.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.