“I use several different bottom dies with our hydraulic press. The one shown in the photo is made from 1 3/4-in. dia., 6-in. long rounds set 4 in. apart on a 1/2-in. thick steel plate. My 50-ton press can bend 1/2 by 6-in. bars on it.
“Top dies have to be made according to the configuration of your press. A square bar could be used, up at 45 degrees, if sufficiently supported vertically.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.