Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 35, No. 1 (2011)

Gene Lamb

Gene Lamb, Centralia, Wash.

“In the early 1970’s I bought a used Leland 384 70 hp tractor, which was my only tractor for many years. In the late 1980’s the clutch went bad so I tore it down, planning to install new clutch plates. Then I discovered the pin-bolts that hold the assembly together were about 3/8 in. into the main bell assembly.

“The dealer wouldn’t even try to repair it and said I needed a new unit that would cost about $700. Instead, I simply built up the worn areas with JB Weld. I let it cure for 24 hours, then put it in the kitchen oven for one hour at 200 degrees. I did this twice, and then put it all together again. The clutch was still running strong in 2007 when the engine failed. It turned out to be a pretty worthwhile $5 repair job.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.