Bob likes to keep a tidy shop. That’s why he created this setup to capture and hold grit and sparks from his chop saw.
It’s an elbow and a small length of 3-in. dia. pipe that’s bent at an angle and leads from the chop saw’s original spark deflector down into a coffee can.
“The chop saw’s original spark deflector is designed to deflect grit and sparks forward instead of straight up. My pipe deflector improves on the idea by capturing most of the material in the coffee can,” says Bugger.
He built a base for the chop saw using an old brake drum and a stand pipe, on top of which he welded a metal table top. The chop saw’s original mounting plate attaches to this plate by a pair of screws.
“If I want to take the saw somewhere else, I just undo the wing nuts on the two screws and carry the saw off,” says Bugger.
The add-on plate extends about 18 in. off to one side of the saw, where cutoff pieces can drop onto it. A short length of pipe that’s welded under the plate serves as a depth guide for cutting multiple pieces to the same length.
“I just bump the piece I want to cut up against the pipe and saw it, then repeat the process.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.