Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 29, No. 5 (2005)

Vilas Noyes

Vilas Noyes, Montfort, Wis.

“I was mounting an engine on a metal frame and had trouble marking where to drill holes with my drill press. I couldn’t get a punch in there and I don’t have an angle-head drill.

“So I took a drill bit of the size to fit the hole and forced a 2-in. piece of rubber hose on the end it. I put another drill bit the same size in my electric drill and punched it into the rubber tape to make a flexible shaft.

“I couldn’t put much pressure on it since the drill just pushed deeper into the hose but I did get a perfect punch mark for my drill press.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.