Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 26, No. 5 (2002)

Dan Krenzel

Individual tip 1 of 2 from this reader’s published contribution.
Dan Krenzel, Cullman, Ala.

“Here’s a good use I found for JB Weld. I had a carburetor needle valve with worn-out threads, which caused the screws to wobble. I lightly vaselined the needle shank threads, then cleaned the carburetor threads well and put a small amount of JB Weld into the outer edge of the entry hole and screwed the needle in all the way. Then I built up the area around the screw with more JB Weld. After setting, the JB Weld held it nice and tight but the vaseline kept the needle from locking in place. Worked great.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.