Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 25, No. 6 (2001)

Robert T. Valentine

Individual tip 1 of 2 from this reader’s published contribution.
Robert T. Valentine, 417 Commercial Ave. S., Wolsey, S. Dak.

“I read about the problems Norman Fiddler has had with front spindles breaking on his Deere 4020 tractor (Vol. 25, No. 5). I had the same problems with my Deere 4010 but I solved it in a different way. I bought a used Case 1370 front axle assembly from Paul Meyers Tractor and Combine Salvage in Aberdeen, S. Dak., and modified it to fit the 4010. I used the 4010’s regular saddle without any modification. We cut the Case cylinder brackets off the back of the Case front end. Then we cut loose the rear bracket that’s welded to the Case wishbone near the back, using the proper size shaft as an alignment guide. We then placed the shaft through the Case front end and through the Deere saddle. Next, we moved the cutout Case mounting ahead so that it’s against the Deere saddle and rewelded it in place.

“The Case tie rod ends are heavier and thicker than the ones Deere uses so we had a local machine shop enlarge the holes in the Deere steering arm in order to accept the Case tie rod ends.

“The machine work was done by folks at the Grasslands Hutterite Colony (11865 - 307 Ave., Wetonka, S. Dak. ph 605 439-3273). Ask for Alvin Wollman or George Waldner, Jr.).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.