Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 24, No. 4 (2000)

Wayne Zimmer

Wayne Zimmer, Roblin, Manitoba

“Here’s a photo of a bolt rack that I made using gangs off an old disk. I can turn it to any position and find anything I want at a glance. I removed the gangs and welded short lengths of angle iron to the bearing holders on all the gangs. I welded two gangs to a pipe opposite each other. The next two gangs are welded opposite each other but are lower than the two gangs welded to the pipe. The stand that holds the rack upright is the rear wheel of a disker which has weights on it.

“The entire rack revolves, which means I can move all four gangs at once, or move each gang one at a time.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.