Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 23, No. 3 (1999)

Mike Graham

Mike Graham, Edison, Ohio

“You can fix a loose head on any size wooden handled hammer using this simple, low-cost method.

“You simply apply JB Weld generously to the end of the handle and inside the head, then put the head back on the handle and reset the head. I first clean the handle thoroughly with sandpaper or steel wool. Likewise, I clean up the inside of the head with a small wire brush. In 24 hours, after the JB Weld sets, you’ve got a hammer that’s as good as new.

“I’ve also used this repair on a couple of 4-lb. sledges I use to break up firewood. It’s a permanent repair.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.