“I re-duced the four lower speeds on my 12-speed drill press by more than half, allowing me to use bigger drill bits and keeping me from burning up bits so fast.
“Instead of turning at about 150 rpm’s, I estimate it now runs at around 50 rpm’s, so I can use bits up to 1 1/4-in. in dia.
“I made a short shaft and mounted it on top of the motor cone pulley and put a 1 1/2 to 2-in. V-pulley on top of the cone drive pulley. I mounted a hub on top of the cone pulley and mounted a 5 1/2 to 6-in. V-pul-ley on that to reduce center pulley speed. I used a longer belt for the speed reducer.
“I had to move the hood over about 1/2 in. in order to close it over the pulleys. We’ve used the drill press like this for several years and like it so much we don’t even bother to change belts for switching back to the original, higher speeds anymore.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.