Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 21, No. 3 (1997)

Dale Spoerl

Dale Spoerl, Elizabeth, Ill.

“When the brakes on my International 560 tractor wore out I came up with a quick, inexpensive way to solve the problem - I made a stainless steel shim that takes up the wear in the brake bands. The brake drum has three bands that hold the discs in place and keep them centered. The bands are about 3/4 in. wide and stand about 1 1/2 in. outside the housing. The lower band was wearing especially bad. Whenever I put the brakes on they grabbed hard and sometimes wouldn’t release unless I backed up.

“I made the shim by using a special tool to bend a .035 thick section of stainless steel into a U-shape, then clamped the shim onto the bottom band so that it can’t move back and forth. I didn’t weld the shim in place because I wasn’t really sure that the idea would work. However, I installed the shims on the brakes of two different tractors and haven’t had any problems with either of them.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.