Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 21, No. 1 (1997)

Jack Gardiner

Jack Gardiner, Ilderton, Ontario

“The moldboards on my International 710 plow had holes worn through them near the center next to the shins. I found a way to keep the moldboards from wearing so that they last a lot longer - whenever I replace the points and shins I reuse the old shins. Since the old shins are shaped the same as the moldboards everything looks custom made. I remove the bottom bolt from the moldboard near the shin. I use a longer bolt to fasten the old shin through the bottom hole onto the moldboard. Then I put a bead of weld on top of the old shin and moldboard. The old shin is sort of layered over the edge of the new shin (about 1/4 in.) and over the moldboard. This adds a lot of metal right where most of the wear occurs on my moldboard. Now my moldboards seem to last forever.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.