“Making large holes in thick steel often re-quires the use of large, expensive power tools. A simple, inexpensive way to cut holes is to make a compass attachment for your cutting torch. Sharpen the end of a 7-in. pole barn spike to a smooth point and make a bend in the spike (as shown). Then flatten the end of a 5/16-in. bolt and drill a hole in it the size of the spike. Slide this through the space between the torch pipes, placing a washer on either side of the pipes and tightening the nut when you have the spike adjusted to the radius you want.
“To aid in adjusting the radius, find a medium size electrical wire connector and substitute a short 5/16-in. fine thread bolt for the standard set screw. Use a short piece of wire that fits the oxygen hole in the cutting tip. Bend a short 90 degree angle in the wire and slide the wire connector to get the exact radius. You can drill a small hole at the edge of the hole to start the cut. Center-punch the hole and place the point of the spike in it. I do the work on top of a small oil barrel with an old tire rim on top so that I can walk 360 degrees around the piece I’m cutting while holding the torch.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.