“My simple corrugated metal cutter is a great way to cut through corrugated sheet metal roofing or siding, whether you’re cutting straight across or at an angle,” says Roberts, who made his metal cutter out of scrap materials.
He made it with four 2 by 4’s and two 1-in. boards. The bottom two 2 by 4’s nail to the top of the two 1-in. boards in an “H” configuration, spaced only about 1/8 in. apart. The top two 2 by 4’s fit over the bottom two 2 by 4’s. Four bolts go down through the 2 by 4’s and the bottom 1-in. boards.
A long piece of galvanized wire is anchored at one side of the unit. A handle is tied to the loose end.
To make a cut, you simply slip a piece of sheet metal between the four 2 by 4’s, and then tighten down the four bolts. Then you loop the wire under the metal and pull it up between the 2 by 4’s on the other side of the metal. When you pull back on the wire, it’ll cut right through the metal.
“I recommend using oak 2 by 4’s on top that have good square edges to make a cleaner cut,” says Roberts, who lays the cutting frame down flat on the ground and stands in the middle of the 2 by 4’s when pulling up on the wire.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.