You can make your own low-cost “roto rooter” out of odds and ends you probably already have on hand, says J.D. Higdon.
Higdon came up with the idea to help a friend clear a 4-in. drainage line.
He first made a cutter head out of a 7 1/ 4-in. circular saw blade. Three pie-shaped pieces were cut out with a torch. Both sides of each of the three prongs were then sharpened on each side.
The three propeller-like blades were next bent forward with a vise-grip as they were heated with an acetylene torch. The hole in the middle of the blade remains centered.
The blade mounts on a 5/8-in., 11 by 3-in. hex-headed bolt. A 1/4-in. dia. hole was drilled about 2 in. deep in the end opposite the threads. Two smaller holes, for set screws, were drilled at 90° through the sides of the bolt.
On the threaded end of the bolt, a 5/8 nut was threaded on and welded in place. The blade then slips on the shaft with teeth facing outwards. A lock washer and another 5/8-in. nut hold the blade in place. A 1/4-in stiff guidewire cable inserts into the head of the bolt and runs to a spool slipped over a 3-in. water pipe. A vise-grip locks the cable to the pipe so he can rotate the spool and pipe together to turn the cutter head.
“We found the obstruction about 60 ft.
into the drain pipe,” says Allison.
“Altogether, it took 80 ft. of cable, including passing through a 90° elbow.” (Back-woods Home Magazine, 1257 Siskiyou Blvd. No. 213, Ashland, Ore. 97520.).
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.