Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 48, No. 6 (2024)

Steven Janis

Individual tip 4 of 4 from this reader’s published contribution.
Steven Janis, Howell, Mich.

“If you have an old AMC/Jeep with low engine pressure, do a copper tube oil bypass under the intake manifold from the front oil passage to a drilled and tapped hole between the number six and eight cylinders in the valley. You can go from 5 lbs. to 30 lbs. pressure with this help. You may have to drill the block oil passage, which was cast too small to a 9/16 bore, and from there, the front cover mounts. Mine was 5/16 dia., which did not provide enough volume. The drill bit was too short, so I cut the end to fit an oil pump drive shaft.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.