Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 48, No. 3 (2024)

Dale Rogers

Dale Rogers, Mayfair, Sask.

“Welding up a shaft often causes it to warp. So, I put a low rpm motor at the end of the lathe and run a belt up to the main big pulley. This way, I can still use all the gear settings to adjust the rpm of the chuck. Then, while the mounted shaft is slowly turning, I use the MIG welder to build up the shaft. Then, while the shaft is cooling down, I continue to turn the shaft, so it doesn’t warp. After it’s well cooled, I can take the extra belt off and lathe it down to size.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.