Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 46, No. 5 (2022)

Tom Chaney

Tom Chaney, Chrisman, Ill.

“When the wobble box pin yoke shattered on my old 990 IH haybine, I figured I was out of business. I couldn’t justify a new machine and no parts were available for the 990.

“This spring the solution hit me. I took 2-in. wide, 1/4-in. flat iron and made 90-degree bends in several pieces and welded them together to make a sleeve to fit over the yoke. One bend went around the front of the yoke, while the other went over the back of it, to the rear of the pin. I welded a nut for filler to the strap that went around the shattered side of the yoke.

“I had to replace the yoke pin that floats in the sickle bar pulling it back and forth. The original was notched for the bolt that pulled the yoke sides together. The notch allowed the bolt to also secure the pin in place.

“I notched the replacement pin with a plasma cutter. Then I drilled a hole through the sleeve to match the hole in the remaining side of the yoke. I bolted it all together and went to the field.

“My first pin couldn’t handle the stress, so I replaced it with a second one that was hardened steel. I put it back together and mowed four acres. It has worked since without a problem.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.