Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 46, No. 5 (2022)

Anthony Coleman

Anthony Coleman, Fork S.C.

“When rebuilding my Argo, the bearings would cut into the axle where the seal runs. I would just weld up the cut and then turn the axle down in my lathe. It took only about 30 min. per axle. There are eight of them and it saved me $100 each.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.