Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 45, No. 4 (2021)

Tom Dufrense

Tom Dufrense, Grant, Minn.

“The drawbar on my Ford utility tractor spins freely in the hitch pins and was a constant annoyance when hooking up trailers or other equipment. So I came up with a pair of ‘stops’ to hold it in place.

“They consist of two 6-in. long pieces of 2-in. sq. angle iron. I drilled two holes into one side of each piece. One hole is used to bolt the stops to each arm of the hitch. When the drawbar is not being used, the stops pivot up and are held in place by zip ties.

“When installing the drawbar, I pivot each stop down and stick the drawbar pin through the hole in the stop before going through the hitch pin hole. The stops hold the drawbar firmly in place with no more spinning.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.