Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 44, No. 4 (2020)

Joe Johnson

Joe Johnson, Meridian, Miss.

“I was working on a 3-cyl. Perkins diesel engine from a Massey Ferguson 150. I needed a way to keep debris from falling into the cylinder bores when cleaning the engine block surface for head gasket replacement.

“Everyone says to stuff rags into the bores but that’s not every effective. Instead, I decided to use coffee filters and grease. Rotate the crankshaft until all pistons are as far from top dead center as possible. Cut each filter (if necessary) so it will fit neatly into the bore without extending above the surface. Place a ring of grease around each bore and press the edges of the filters into the grease. After scraping and sanding the block, carefully remove each filter and wipe down the bores. No debris will have gotten into the cylinders.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.