Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 42, No. 5 (2018)

Bob Payne

Bob Payne, Coldwater, Miss.

“A couple of years ago I got a good deal on a heavy steel shop table, but I wasn’t sure where to place it in my shop. Putting the table against a wall would limit its use for big projects, and putting it in the middle of the shop would take up too much space. Instead I welded angle irons between the legs on both sides of the table, about 6 in. above a shelf, and then bolted boat trailer jacks onto them.

“To move the table I just crank the jack handles a few times to raise the table off the floor. Once the table is in place, I lower the table legs back onto the floor to keep flat spots from forming on the jack wheels.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.