Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 40, No. 5 (2016)

Doug McAlexander

Doug McAlexander, Cedar Grove, Tenn.

“I have a riding mower with 12 by 8.5 rear wheels that fit tightly on the axle and are held on by keys that keep the axle from turning inside the wheel. One of the wheels got loose when the keyway was worn down so the only thing holding it on was a snap ring at the end of the axle. There wasn’t enough room to tap a set screw in the 2 or 3-in. space between the rim and hub, so I removed the tubeless tire from the rim. Then, with the aid of a large vise to hold the wheel, I drilled a 5/16-in. hole through the rim and hub, 180 degrees from the keyway. I drilled the hole as far out as possible on the hub.

“I put a nut on a 5/16-in. bolt and inserted it through the holes in the wheel and hub. Then I braze welded the nut to the hub and welded the hole shut to make the rim airtight so it could be used as a tubeless tire again.

“I spray painted the wheel, then put the tire back on, removed the bolt and put the wheel back on the axle. Then I inserted the bolt through the hole in the hub and into the welded-on nut. Then I tightened the bolt down tight to hold the wheel against the axle.

“Loose wheel problem solved.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.