“The secondhand scaffolding I bought to paint my house uses wing nuts to fasten the cross braces. I realized the nuts needed to be tighter when I walked around the scaffolding and saw the braces had become loose. I tried using a hammer to tap the wing nuts around, but the wings kept breaking off the nuts. So I developed this wrench to apply equal pressure to both wings on the nut as it’s tightened. It works great.
“I started with a 1 by 8-in. flat plate that was 3/16 in. thick. I drilled a 1/2-in. dia. hole about 1 1/4 in. from one end and then reamed it out one size larger. Then I put it in a vice fixture on my lathe and chucked up a 1/4-in. mill bit. I centered it in the previous hole and ran it out 1 in. in both directions. The last step was to round the corners and clean up the burrs.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.