“I made a C-clamp so I could replace a U-joint on the driveshaft on my 1995 Chevy 2500 pickup. The driveshaft and yoke on older pickups like mine are made from aluminum so I didn’t want to risk beating on it with a hammer. Commercial clamps sell for $130, but I used scrap metal for mine.
“To make the clamp I first measured, then made a pattern, traced it and cut it out of 1-in. thick plate steel. I welded one nut on top of the clamp and another nut at the bottom that serves as a spacer. To press the yoke out, I place it inside the clamp and then use a socket wrench to turn a threaded bolt that goes through the top nut.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.