Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 34, No. 2 (2010)

Wayne Gray

Wayne Gray, Hayden, Colo.

“When re-placing the clutch on a pickup you also have to replace the pilot bearing, which can easily get stuck in the flywheel. Unfortunately, most of the time you can’t fit a tool in behind the bearing in order to pry it out.

“To make it easier to pry the bearing out, I squirt three or four shots from a grease gun into the middle of the bearing. Then I find a punch that’s about the same diameter as the inside diameter of the bearing, and use the punch to force the grease behind the pilot bearing, which will then push the bearing out of the flywheel. It works almost like a hydraulic press. Electrical tape can be used to make a snug fit around the punch and the hole.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.