Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 32, No. 4 (2008)

Skid Steer Repowered With 16 Hp Briggs & Stratton

Featured source: Chris Kornkven

When the original engine on his old Case 1816 skid steer loader went bad, C h r i s Kornkven, Helenville, Wis., replaced it with a new Briggs & Stratton 16 hp engine.

“It was the first snow of last winter and, with three driveways to clear, I fired up the skid loader. A few hours later I was finishing with the last bit of snow when the engine suddenly lost power.

“I managed to limp the skid loader back to my shop. I contemplated taking the engine out and rebuilding it, but I thought it would be nearly impossible to find parts, even if I could quickly identify the problem. I also didn’t think I’d have the time to rebuild it before the next snow fell.

“The factory engine on my Case 1816 was a Tecumseh OHC160 16 hp model.”

Kornkven had remembered reading in FARM SHOW about other readers who re-powered skid loaders, so he searched the internet for more info. He came across “smallenginewarehouse.com”, an Indiana company that sells repower kits and engines.

“Smallenginewarehouse recommended a 16 hp Briggs & Stratton Vanguard engine for my machine because of the dimensions of that engine. I ordered one, and it arrived about three days later,” says Kornkven.

“I had to fabricate motor mounts for it since the bolt holes wouldn’t line up. Everything else worked out better than I expected. The gas line, wiring, throttle and choke cables and even the original belts matched up. However, the muffler interfered with the cross-connect between the hydraulic tanks so I had to use a different one. After a couple of days I was able to start my skid loader up and drive it. It was quite a relief since it snowed again a couple of days later. It snowed a lot the rest of the winter, and the repowered loader always started and ran great.”

Kornkven says total cost of the project was about $1,200.

“It was money well spent. The new engine has plenty of power, and it’s much easier on gas than the old one.”

Contact: FARM SHOW Followup, Chris Kornkven, N6280 County P, Helenville, Wis. 53137 (ph 920 699-2376).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.