Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 30, No. 4 (2006)

James Burden

James Burden, Crystal River, Fla. (ph 352 794-0497)

“I bought some acreage next door last year that apparently had a lot of hidden metal debris on it. As a result it wasn’t long before I had three flat tires on my Deere L100 riding mower. To solve the problem, I bought a $10 magnet at Harbor Freight (www.harborfreightusa.com) and attached it to the back of the riding mower, about 1 in. off the ground. So far the magnet has picked up two full coffee cans of nails, screws, brads, staples, wires, paper clips, bottle caps, and brackets. At the same time, I put a stop leak product in the mower’s tires and haven’t lost any air since then.

“The magnet measures 4 by 8 in. and has a couple of mounting holes. To position the magnet as close to the ground as possible, I screwed a 2 by 4 to the top of the magnet and then wired the 2 by 4 to the back of the tractor.

“The magnet is rated at 250 lbs. The mower is equipped with a 42-in. deck and the magnet is only 8 in. long. However, its pull reaches out a few inches to either side so it won’t take too many passes before the magnet will have covered the entire yard.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.