“Several years ago I did welding and mechanic work for a liquid fertilizer company. The company bought an extra truck and there was no room to install an air compressor on the motor. The truck needed a pto in order to operate the liquid fertilizer pump. To solve the problem, I built a bracket that mounts between the cab and the tank above the pto shaft, allowing the pto shaft to belt-drive the pump, since the liquid pump has to work at the same time as the air pump.
“I tapped into a pressure oil line on the truck’s engine and ran it back to the air compressor. Then I ran a return line back to the engine and tapped into the oil pan above the oil level. I also tapped into the water line to the compressor and engine with a pressure and return flow of water back to the engine.
“Because of dusty conditions, I ran a rubber hose from the compressor to up behind the seat of the truck cab to the compressor’s air filter. The truck needed an air compressor for two reasons: one, to open the air valve for the liquid fertilizer to flow from the tank and two, so that I could install a lock in and out for the pto on the transmission.
“I spring loaded the pto gearbox in the out position and used a small air cylinder from the shutters that close in front of a semi radiator to put the pto in gear, because I only needed it when putting out fertilizer.
“The truck was wrecked several years later and scrapped out. But it all worked fine for the years that I used it.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.