Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 30, No. 1 (2006)

He Machines Drill Bits

Featured source: Robert Rottinghaus

Here’s a tip for do-it-yourself machinists submitted by Robert Rottinghaus of Jesup, Iowa.

He used his lathe to convert two large drill bits with a Morse taper to an R-8 shank.

“A lot of today’s drill presses don’t have enough vertical clearance to use Morse taper adapters with a big drill. For example, I have a Bridgeport mill that doesn’t have thrust bearings in it and is made for milling only. As a result, I can’t crank the drill press up high enough to put all my adapters on. If I do, the sleeves will hit the table.

“So instead I chucked the drill bit into my lathe and machined it down to fit the R-8 spindle. Do the machining before you saw off the Morse taper flat. You then will have a counter sink hole for the tail stock on your lathe.”

Contact: FARM SHOW Followup, Robert Rottinghaus, 5121 S. Canfield Rd., Jesup, Iowa 50648 (ph 319 827-1311; fax 319 827-2425).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.