Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 29, No. 6 (2005)

Gary Elston

Individual tip 1 of 3 from this reader’s published contribution.
Gary Elston, Mulvane, Kansas

“Removing worn out gang bearings from a disk is a tough mechanical problem that many farmers face at one time or another. The problem is that the bearing almost always seizes to the shaft. I find the easiest way to remove the collar is to either heat it with a torch and beat it off, or carefully torch it off. After the collar is off, use a grinder with a wire wheel to thoroughly clean off all the rust and dirt. Once the surface is cleaned, inspect for nicks or burrs which may interfere with installation of the new bearing. Before installing the bearing, use an anti-seize lubricant to thoroughly coat both the bearing and the shaft. The next time the bearing has to be removed, it’ll slide right off.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.