Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 29, No. 4 (2005)

Bayard E. Young

Bayard E. Young, Elkwood, Va.

“Three of the floor chain guides on my New Holland 847 round baler wore all the way through due to the chains wearing on them. The problem is worst on the middle guides, which bear most of the bale’s load. The chains wears grooves in the guides and then through the baler floor. Eventually they get hung up and stop turning, which jams up the machine big time. We kept breaking shear pins, and eventually the main shaft that operates the apron chains broke. I ended up having to replace all seven of the chain guides on my baler.

“Unfortunately these guides aren’t as easy to change as the manual describes. You have to crawl under the baler, where there’s going to be an accumulation of rotten hay and rust to deal with, to unscrew the bolts that hold the guide channels. Someone will have to help hold the bolts while you remove the nuts.

“So if you have a baler with chains instead of belts, my advice is to examine the guides and if they look like they’re wearing, add hard surface welding material to fill in the grooves.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.