Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 29, No. 2 (2005)

Eugene Keener

Eugene Keener, Smithville, Ohio

“Welding cast iron is much easier than people think. Instead of using a ni-rod, I use a no. 7018 in a DC reverse polarity mode. I treat the cast iron the same as if I were using ni-rod. However, the 7018 rod is much cheaper and holds better. Of course, if it’s a small cast item, it’s best to heat the whole item to 400° or so and it’ll weld much better. If the casting is too big to do that, I just weld a little at a time – an inch or so in length – then take a ballpeen hammer or a pointed chipping hammer - and mark it so it stretches out and doesn’t pull loose from the rigid cast. I don’t start welding another section until I can put my bare hand on the last one. This prevents the piece from getting too hot.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.