“I came up with an easy and inexpensive way to keep chains from wearing out on my 1981 New Holland 847 round baler. I bolted an oil reservoir onto the endgate that automatically applies a steady stream of oil to chains every time I raise the endgate,” says Bayard Young, Elkwood, Va.
Young enclosed the ends of an 8-in. dia. steel tube with steel plates and then bolted the plates to the top of the endgate. He attached valves fitted with rubber hose to both ends of a 1-in. dia. pipe mounted parallel to the oil reservoir and about 1 ft. ahead of it. A vertical breather pipe mounts above each valve.
“It cost only about $100 to put together,” says Young.
“My neighbor Richard Dwyer did the welding work on the tube. It took a little experimenting to get everything to go just right. The breather pipes have to be long enough to keep oil from spilling out of them whenever the tailgate is raised. I put the pipe in the middle of the tube, which can be a problem on hilly ground because all the oil flows to one end of the tube. It would probably work better if there were two pipes coming out of the tube, one at each end.”
Contact: FARM SHOW Followup, Bayard Young, 18172 Youngs Lane, Elkwood, Va. 22718 (ph 540 399-1405).
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.