Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 29, No. 1 (2005)

Bill Wilson

Individual tip 2 of 2 from this reader’s published contribution.
Bill Wilson, 44 Gable Road, Thompson Falls, Montana 59873 ph 406 827-3006)

“I love doing mechanical work but hate looking for shop tools, so I used a 4 by 8-ft. sheet of plywood to come up with my own two-sided toolboard. It mounts on an angle iron frame and rides on rollers. It lets me roll my tools right out to whatever I’m working on.

“It’s really handy. As soon as I’m done using a wrench I put it right back on the toolboard instead of laying it down somewhere. Whenever I need to use that size wrench again, I know right where it is without having to look for it. The toolboard is narrow enough to fit through a 32-in. wide door. I keep end wrenches and sockets on the front side. All the sockets and end wrenches of the same size line up vertically. So, a 5/8-in. impact socket will have a 5/8-in. standard socket immediately above it. Impact wrenches and hammers, hacksaws, etc., are on the back side of the board.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.