Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 28, No. 5 (2004)

H.L. Baggett

H.L. Baggett, Hollow Road, Tenn.

“I traded for a Snapper SRI30 riding mower with a 12 hp. Briggs & Stratton engine. Unfortunately, it had a lot of problems so I had to do some work on it.

“I cut 2 in. off the forward bottom edge of the deck, giving the blades a more open-angle to cut the grass and weeds. I also welded the deck-lift arm to the deck lift shaft to strengthen it. And I bolted chain in place of the original ‘fishing line’ dia. decklift attachments at the rear of the deck.

“In addition, I moved the seat back 7 in. to accommodate my girth. I mounted the steel seat on hinges to make it easier to change the air filter. And I replaced the two-piece carb with an old single-piece carb.

“I put roller thrust bearings on the front spindles, to ease steering between the axle and lower washer on the spindle. Finally, I repainted the tractor.

“This mower now cuts 4-ft. tall weeds and brush at 1/4 throttle. In fact, I mowed an acre of 4-ft. high weeds and brush on 1 gal. of gas. Cutting off the front 2 in. on the deck made it much easier for the mower to cut tall stuff.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.