“I’ve had problems breaking axle bolts on my Case 1845 Uni-Loader. Replacing the bolts is tough because I can’t get my hand into the holes to install them. I called the dealer and was told to pull the axle housing off. However, after studying the situation I came up with a better way. I welded a small nut on the end of an axle bolt. The nut is smaller than the diameter of the bolt and sits on its side. I used low temperature when welding the nut to avoid damaging the bolt. Then I took a piece of mechanic’s wire and fished it through the axle bolt hole and up through the axle chain inspection hole. I run the wire through the small nut and pull the bolt through the hole and put the nut on. This procedure saved me hours of downtime and a lot of work. I always keep at least one axle bolt - with a nut attached to it - on hand in case of an emergency.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.