Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 28, No. 1 (2004)

Ken Armstrong

Ken Armstrong, Box 340, Point, Texas 75472 (ph 903 598-2855)

“Several years ago I knocked out the gearbox on my old Vermeer 605E round baler. My dealer said the company no longer made that gearbox and that I’d have to adapt a new gearbox designed for Deere balers which would’ve cost about $500. I didn’t want to spend that much money so I took the rear end out of a 1972 Ford car and welded it up solid to convert it into a gearbox, which I mounted in place of the original gearbox. Then I bought a sprocket and mounted it on the end of the axle. The sprocket was sized to keep the speed the same as the baler speed. Then I hooked the tractor’s pto shaft to the gearbox. My total cost was about $125. I made the change nine years ago and haven’t had any problems at all.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.