Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 27, No. 2 (2003)

Dwight Ruhlen

Dwight Ruhlen, 2591 Halcyondale Rd., Sylvania, Ga. 30467 (ph 912 863-4398)

“Using nothing more than a 2-ft. long harrow shaft and a cast iron spacer, I made a cheap slide hammer that I use to pull keys out of a keyway on our Case-IH 8465 round baler. The keys hold a couple of pulleys in place. I installed a pair of nuts and a washer on one end of the shaft. The other end of the shaft is square. I made two different size notches in the square that fit behind the raised part of the key. The spacer weighs about 4 lbs., so a sudden pull of the slide back against the washer creates enough impact to break the key loose. I got most of the parts I needed at an agri-supply store for a total cost of $28. Commercial slide hammers sell for $100 to $250.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.