Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 26, No. 2 (2002)

Raymond A. Miettinen

Raymond A. Miettinen, Republic, Mich.

“A U-joint went out on the front driveshaft on my Ford 3/4-ton pickup, which ruined a bearing mount on the transfer case. It would’ve cost a lot to repair so I solved the problem myself. I took the transfer case apart, then cut a 1 1/2-in. wide strip from a coffee can and used a disc grinder to cut notches into it to fit over the gussets. I fitted it around the ribs and used clay to seal it. I centered the new bearing, then installed the snap ring and old bearing on top. I poured lead around the bearing and also put a new seal on the outside. Now it works fine and cost very little. I drilled holes and put small bolts in the gussets in order to make a good bond for the lead.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.