“I built these steps in less than 2 hours on my 3010 Deere. I’ve been crawling on and off 10 and 20 Series tractors since they were new. This step is a great improvement, especially getting off. Wish I’d thought of it 35 years ago.
“What I did was to remove both existing steps. Then I took a piece of 2 by 2 by 7-in. steel tubing and drilled holes in it to match the holes where the steps were mounted. Next, I take a piece of 1/2-in. thick strap iron, 22 in. long by 2 in. wide, and make a bend at 12 in. Weld the piece of steel tubing to the back side of the L-shaped strap iron, about 5 in. from the top. Finally, turn the existing Deere steps upside down and weld them to the top and bottom of the ‘L’. And then bolt the whole assembly to the tractor.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.